Butler Winding
Home
Butler Winding, 201 Pillow Street, Butler, PA 16001, 724-283-7230
Request a Quote from Butler Winding
JOB POSTINGS
Custom Transformers - Custom Design
Toroidal Transformers - Custom Built
Bobbin Wound Transformers - Custom Built
Power Transformers - Custom Designed
Common Mode Choke - Custom Designed & Built
Switch Mode Power Transformers - Custom Built
Flyback Transformers - Custom Built
Pulse Transformers - Custom Built
Current Transformers - Custom Built
Surface Mount Transformers - Custom Built
Custom Inductors
Toroidal Inductor - Custom Design
Surface Mount Inductor - Custom Design
Bobbin Wound Inductors - Custom Built
Mag Amp Magnetic Amplifier Custom Built
Transformer Core Types - Custom Built
Custom Winding Capabilities - Custom Design
Resource Library
About Butler Winding
Privacy Policy by Butler Winding
Email Sign Up
Our Blog
NAV Facebook

     Bobbin Wound Transformers - Custom Built  
 

Request a quote

PHOTOS Bobbin Wound Custom Projects

PHOTOS Bobbin Winding Process

Bobbin Wound Transformer Theory




Butler Winding designs and manufactures Bobbin Wound Transformers for a variety of power supply and power conversion applications. Bobbin wound transformers may be designed in a wide variety of shapes and sizes.

A Bobbin Wound Transformer is a transformer that is designed with the coil wound on a coil form or bobbin. The core structure is then mounted to the bobbin. Bobbin wound transformers can be designed to operate from 60Hz, or line frequency, well into the MHz range.

Where are Bobbin Wound Transformers found?

  • Switch mode power supplies
  • Power conversion applications
  • Circuit isolation applications
  • Filter circuits
  • Any application that the transformer can be designed on a bobbin or coil form
  • Design upper limits of a Power Transformer:

Typical minimum requirements to be specified for a Bobbin Wound Transformer are:

Power rating in VA.
Operating frequency in Hz.
Number of primary windings.
Number of secondary windings.
Operating voltages levels.
Operating current levels
Operating frequency is needed for core calculations and wire sizing.
Core material is selected for the known operating frequency or frequencies which can be anything from silicon steel laminations to a ferrite core structure.
Other bobbin wound transformer design considerations are space limitations and mounting technique.
Lead terminations, if needed, may also be specified through the design of a Bobbin Wound Transformer.

Bobbin wound transformer designs vary widely in terms of power rating, voltage and current levels (turns ratios), operating frequency, size, impedance, bandwidth (frequency response), packaging, winding capacitance, and other parameters.

Bobbin Wound Power Transformer

Railroad lighting power transformer with custom terminal board.

Bobbin Wound Power Transformer

Power transformer image shows leads coming off the windings.

 
Bobbin Wound Power Transformer

Side view of power transformer showing (blue) ring tongue connecting wiring to custom board.

Bobbin Wound Power Transformer

Image shows the primary windings (left) and the secondary windings (right).

 


 
 
 


 


Butler Winding
201 Pillow Street  Butler, PA 16001
Phone: 724-283-7230  |  Fax: 724-283-8799

Copyright © 2014