This Bobbin Wound Power Transformer was built to mount on a chassis panel.
- Input Voltage: Dual Primary (2 x 115V)@60Hz
- Output Voltage: 2 x 80V @ 1A, CT. w/ CenterTap Windings
- Core Structure: E-I Lamination, SiFe, Interleaved
- Dimensions: 3-1/8″H x 3-3/4″W x 2-7/8″D
- Hole Spacing: 3-1/8″ x 2-7/8″, center to center
- Coating: Air Dry Varnish, 130 degrees C.
- Unit weight: approximately 5 pounds.
- Part Number: 10-0134
This Bobbin Wound Inductor was built to mount on a printed Circuit board using through hole technology.
Basic Design: Unit has one “Trifilar” wound coil. Trifilar winding produces three coils which have nearly identical characterics.
- Turns Ratio: N1:N2:N3=1:1:1
- Inductance Rating: L1=L2=L3= 58-71uHy @ 1kHz.
- Core Structure: Ferrite PQ Core.
- Coating: Air Dry Varnish, 130 degrees C.
- Unit Weight: Approximately 41.6 grams.
- Part Number: 130-0033
This Bobbin Wound Inductor was built to mount on a printed Circuit board using through hole technology.
- Application: Timer Transformer
- Turns Ratio: NP:NS= 1:2.14
- Inductance: LPrimary= L 1-4=29-67 mHy LSecondary= L 5-8+ 136-308 mHy
- Core Structure: Ferrite Pot Core
- Coating: Air Dry Varnish, 130 degrees C
- Unit Weight: Approximately 20 grams
- Part Number: 70-0257
